myoung84
02-14-2012, 11:00 AM
I got my switch plate in yesterday and made a simple relay pack for it that will mount behind the dash somewhere. I only wired up the coil side at this point so I will just have to wire up the contacts as needed later when I add accessories. Not in a huge rush to install it just yet since I have nothing to power with it, but I did test it with a 12V power supply and it works like it should. Two of the wires get wired to a switched 12V source and one to ground. Then one side the coil to 12V and the other side to each output from the switch. I wired it up so I just have a 12V wire to connect and a ground.
http://i1089.photobucket.com/albums/i360/myoung84/Misc/IMG_20120213_174041.jpg
http://i1089.photobucket.com/albums/i360/myoung84/Misc/IMG_20120213_174233.jpg
http://i1089.photobucket.com/albums/i360/myoung84/Misc/IMG_20120213_174125.jpg
http://i1089.photobucket.com/albums/i360/myoung84/Misc/SwitchPackInstall.jpg
http://i1089.photobucket.com/albums/i360/myoung84/Misc/IMG_20120213_174041.jpg
http://i1089.photobucket.com/albums/i360/myoung84/Misc/IMG_20120213_174233.jpg
http://i1089.photobucket.com/albums/i360/myoung84/Misc/IMG_20120213_174125.jpg
http://i1089.photobucket.com/albums/i360/myoung84/Misc/SwitchPackInstall.jpg